REQUEST-TO-EXIT Red LED Passive Infrared Sensor Available in white or brown enclosure
DESCRIPTION
The product has been given as the following : ALEPH High Performance Request‑to‑exit Detector.
Aleph OD22 FEATURES
• Door monitor with sounder alert
• Internal vertical pointability
• High sensitivity
1. SPECIFICATIONS
| Supply Voltage | 12-24VDC or VAC . |
| Supply Current | 18-30mA@12-24VDC,45-80mA@12-24VAC |
| Relay Output | 2C Contact(N.C/N.O) , 24VDC 1A Max. |
| Detection Type | Passive infrared |
| Relay Hold Time | 0.5-64 seconds |
| LED Indication | Red |
| Range | Coverage 12x5 ft at 7ft high,30x12 ft at 15 ft high(Adjustment ) |
| Operating Temperature | - 14°F to 131°F(- 10° C to 55°C) |
| Weight | 0. 4lb( 0. 18kg) |
| Humidity | 0-95% non-condensing |
| Dimensions | 6.53"Wx1. 57"Hx1. 53"D( 166x40x39mm) |
2. DIMENSIONS
3. DESCRIPTION AND OPERATION
4. DETECTION PATTERN
5. INSTALLATION
Mounting Procedure
1. Select a mounting location over the center of the door or doors to be covered. The target must walk
directly toward the detector.Mount the detector on the ceiling,wall,or door frame.
2. Remove the front cover from the detector.
3. Route the wiring as necessary through the wiring entrance(refer to the item 3 description and oper- ation).For surface wiring,use the break out wiring entrance on the front cover(at the same end as the wire entrance).
4. Loosely mount the back cover to the mounting sur- face using the supplied mounting screws.
5. Aim the detector for the desired coverage.
6. Mount the front cover on the detector.
Long Range/Short Range Adjustment
The OD-22 can be set to detect individuals at either a long rang(several steps from the door) or at short range (immediately in front of the door).If the build- ing includes a lengthy approach to the exit doorway and no other foot traffic in the area, choose the long range setting.
Setup and Testing
1. Apply power to the unit.
2. Wait at least 3 min for the detector to settle.
3. Test the unit by walking directly throgh the coverage area,to- ward the door.
4. Aim the detector up or down if necessary to obtain the proper coverage.
5. Check that the relay latch time is sufficient Adjust if necessary.
6. After confirming proper operation,replace the cover and walk test one more time to ensure the coverage has not changed.
